Netgear GS724TS-100NAS 사용자 설명서

If successful, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, 
Rx

 

= x Min/Max/Avg RTT = x/x/x msec.”

If a reply to the ping is not received, you will see “Reply From IP/Host: Destination 

Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.

To display this page, click Maintenance 

 Troubleshooting  Traceroute.

 

To configure the Traceroute settings and send probe packets to discover the route to a host 
on the network:

In the Hostname/IP Address field, specify the IP address or the hostname of the station 

you want the switch to ping. The initial value is blank. This information is not retained 

across a power cycle.

Optionally, configure the following settings:

Probes Per Hop. Specify the number of times each hop should be probed. The valid 

range is 1–10.

MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid 

range is 1–255.

InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range 

is 0– 255.