Netgear GS724TS-100NAS 사용자 설명서
Chapter 3: Configuring Switching Information
|
73
GS716Tv2 and GS724Tv3 Software Administration Manual
6.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7.
If you make any changes to the page, click Apply to apply the changes to the system.
Flow Control
IEEE 802.3x flow control works by pausing a port when the port becomes oversubscribed
and dropping all traffic for small bursts of time during the congestion condition. This can lead
to high-priority and/or network control traffic loss. When IEEE 802.3x flow control is enabled,
lower speed switches can communicate with higher speed switches by requesting that the
higher speed switch refrains from sending packets. Transmissions are temporarily halted to
prevent buffer overflows.
and dropping all traffic for small bursts of time during the congestion condition. This can lead
to high-priority and/or network control traffic loss. When IEEE 802.3x flow control is enabled,
lower speed switches can communicate with higher speed switches by requesting that the
higher speed switch refrains from sending packets. Transmissions are temporarily halted to
prevent buffer overflows.
To display the Flow Control page, click Switching
Ports, and then click the Flow Control
link.
To configure global flow control settings:
1.
From the Global Flow Control (IEEE 802.3x) Mode field, enable or disable IEEE 802.3x
flow control on the system. The factory default is Disable.
•
Enable. The switch sends pause packets if the port buffers become full.
•
Disable. The switch does not send pause packets if the port buffers become full.
2.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3.
If you change the mode, click Apply to apply the changes to the system.