Netgear M4100-D10-POE 사용자 설명서
Switching Commands
27
ProSafe M4100 and M7100 Managed Switches
show port description
This command displays the port description for every port.
Format
show port description <slot/port>
Mode
Interface
Description
show port status
This command displays the Protocol-Based VLAN information for either the entire system, or
for the indicated group.
for the indicated group.
Format
show port status {<slot/port> | all}
Mode
Interface
Media Type
STP Mode
Physical Mode
Physical Status
Link Status
Loop Status
Partner Flow
Control
Control
Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
228. To assign an
Privileged EXEC
Term
Definition
Valid slot and port number separated by forward slashes
Shows the port description configured via the “description” command
Privileged EXEC
Term
Definition
Valid slot and port number separated by forward slashes.
“Copper” or “Fiber” for combo port.
Indicate the spanning tree mode of the port.
Either “Auto” or fixed speed and duplex mode.
The actual speed and duplex mode.
Whether the link is Up or Down.
Whether the port is in loop state or not.
Whether the remote side is using flow control or not.