Netgear M7100 사용자 설명서

19.   

Switch Stacks

This chapter describes the concepts and recommended operating procedures to manage 
NETGEAR stackable managed switches running release 4.x.x.x or newer. 

This chapter includes the following topics:

•     Switch Stack Management and Connectivity 

•     The Stack Master and Stack Members 

•     Install and Power-up a Stack 

•     Switch Firmware 

•     Configure a Stacking Port as an Ethernet Port 

•     Stack Switches Using 10G Fiber 

•     Add, Remove, or Replace a Stack Member 

•     Switch Stack Configuration Files 

•     Preconfigure a Switch 

•     Renumber Stack Members 

•     Move the Stack Master to a Different Unit  

Switch Stack Management and Connectivity

You manage the switch stack through the stack master. You cannot manage stack members 
on an individual basis. To access the stack master, use either a serial connection to the 
switch master’s console port, or a Telnet connection to the IP address of the stack.

You can use these methods to manage switch stacks:

Web Management Interface.

CLI (over a serial connection).

A network management application through SNMP.