Netgear M7100 사용자 설명서

다운로드
페이지 559
62
   
|    
Chapter 4.  Port Routing 
 
ProSafe M4100 and M7100 Managed Switches 
Enable Routing for the Switch
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enable Routing for the Switch
The following script shows the commands that you would use to configure a M4100 and 
M7100 Managed Switch to provide the port routing support shown in 
61.
Use the following command to enable routing for the switch. Execution of the command 
enables IP forwarding by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing 
(Netgear Switch) (Config)#exit
Web Interface: Enable Routing for the Switch
1. 
Select Routing > IP > Basic > IP Configuration
A screen similar to the following displays.
2. 
For Routing Mode, select the Enable radio button.
3. 
Click Apply to save the settings.
Enable Routing for Ports on the Switch
Use the following commands or the web interface to enable routing for ports on the switch. 
The default link-level encapsulation format is Ethernet. Configure the IP addresses and 
subnet masks for the ports. Network-directed broadcast frames will be dropped. The 
maximum transmission unit (MTU) size is 1500 bytes.