Netgear M4100-24G-POE+ 사용자 설명서

Port Configuration Commands

This section describes the commands you use to view and configure port settings. 

This command gives you access to the Interface Config mode, which allows you to enable or 
modify the operation of an interface (port).

interface <slot/port>

This command gives you access to the vlan virtual interface mode, which allows certain port 
configurations (for example, the IP address) to be applied to the VLAN interface. Type a 
question mark (?) after entering the interface configuration mode to see the available options.

interface vlan <vlan id>

This command gives you access to the LAG (link aggregation, or port channel) virtual 
interface, which allows certain port configurations to be applied to the LAG interface. Type a 
question mark (?) after entering the interface configuration mode to see the available options. 

The IP address cannot be assigned to a LAG virtual interface. The 

interface must be put under a VLAN group and an IP address 
assigned to the VLAN group.

This command enables automatic negotiation on a port.

auto-negotiate

Global Config

Global Config

interface lag <lag id>

Global Config

enabled

Interface Config