Netgear M4100-24G-POE+ 사용자 설명서

This command enables tracing of ISDP packets processed by the switch. ISDP must be 
enabled on both the device and the interface in order to monitor packets for a particular 
interface.

debug isdp packet [{receive | transmit}]

This command disables tracing of ISDP packets on the receive or the transmit sides or on 
both sides.

no debug isdp packet [{receive | transmit}]

Priority-Based Flow Control Commands

Ordinarily, when flow control is enabled on a physical link, it applies to all traffic on the link. 
When congestion occurs, the hardware sends pause frames that temporarily suspend traffic 
flow. Pausing traffic helps prevent buffer overflow and dropped frames. 

Priority-based flow control provides a way to distinguish which traffic on physical link is 
paused when congestion occurs, based on the priority of the traffic. An interface can be 
configured to pause only high priority (i.e., loss-sensitive) traffic when necessary to prevent 

Total number of ISDPv1 packets transmitted

Total number of ISDPv2 packets received

Total number of ISDPv2 packets transmitted

Number of packets received with a bad header

Number of packets received with a checksum error

Number of packets which failed to transmit

Number of invalid packets received

Number of times a neighbor entry was not added to the table due to a full 
database

Displays the number of times a neighbor entry was added to the table 
without an IP address.

Privileged EXEC

Privileged EXEC