Netgear M4100-D12G 사용자 설명서

This command displays a summary of policy-oriented statistics information for all interfaces 
in the specified direction. 

show service-policy {in|out}

The following information is repeated for each interface and direction (only those interfaces 
configured with an attached policy are shown):

MAC Access Control List (ACL) Commands

This section describes the commands you use to configure MAC ACL settings. MAC ACLs 
ensure that only authorized users have access to specific resources and block any 
unwarranted attempts to reach network resources. 

The following rules apply to MAC ACLs:

The maximum number of ACLs you can create is hardware-dependent. The limit applies 

to all ACLs, regardless of type.

The system supports only Ethernet II frame types.

The maximum number of rules per MAC ACL is hardware-dependent.

This command creates a MAC access control list (ACL) identified by <name>, consisting of 
classification fields defined for the Layer 2 header of an Ethernet frame. The <name> 
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely 
identifying the MAC access list.

If a MAC ACL by this name exists, this command enters Mac-Access-List config mode to 
allow updating the existing MAC ACL.

The CLI mode changes to Mac-Access-List Config mode when you 

successfully execute this command.

Privileged EXEC

Valid slot and port number separated by forward slashes.

The current operational status of this DiffServ service interface.

The name of the policy attached to the interface.