Netgear WFS709TP-100NAS 사용자 가이드

Configuring the Captive Portal

8-5

Select the options desired, then click Apply to apply the configuration. 

The Captive Portal Authentication page allows you to choose the authentication servers to be used 
for user authentication:

1. From the Choose an Authentication Server a pull-down menu, to select the authentication 

server that will be the primary server.

2. Click Add for the selection to be applied.

3. To add additional authentication servers as backup servers, repeat steps 1 and 2.

Servers are listed in order of descending priority. The first entry is always the primary server

4. (Optional) To change the list order, use the up or down arrows to move an entry higher or 

lower in the list.

5. Click Apply.

By default, HTTPS is used on redirection to the Captive Portal page. If you need to use HTTP 
instead, do the following:

Login Page Location

The page that appears for the user logon. This can be set to 
any URL.

/auth
/index.html

Logon Wait Interval

Time range, in seconds, the user will have to wait for the logon 
page to pop up if the CPU load is high. Works in conjunction 
with the CPU Utilization Threshold.

5–10 seconds

CPU Utilization 
Threshold

If CPU utilization is above this percentage, the Logon Wait 
Interval is applied.

60%

Match ESSID List (Base 
operating system only)

Specifies the ESSIDs on which the Captive Portal is enabled.

Proxy Host: Port (Base 
operating system only)

Specifies the IP address of the proxy host and port used for 
HTTP or HTTPS access.

Wired-to-Wireless 
Roaming ESSID List

Allows authenticated user to remain authenticated when 
roaming between wired and wireless networks.

Captive Portal Authentication Browser Interface Page Options  (continued)