Netgear WFS709TP-100NAS 사용자 가이드

RF Plan

4-7

When width and length are specified, RF Plan creates a rectangular area in the Planning 
feature pages that represent the overall area covered by the building. You need to import an 
appropriate background image (

) to aid you in 

defining areas that don’t require coverage or areas in which you do not wish to deploy APs and 
AMs (

).

•

Inter-Floor Height. This is the distance between floor surfaces in the building. 

The valid range for this field is any integer from 1 to a value corresponding to 1x10

12

.

•

Floors. Enter the number of floors in your building. The valid range for this field is any 
integer from 1 to a value corresponding to 1x10

12

.

•

Unit. Specify the unit of measurement for the dimensions you specified on the page. The 
choices are feet and meters.

The AP Modeling Parameters page (

) allows you to specify the information necessary 

for RF Plan to determine the appropriate placement of your APs.

Controls on this page allow you to select or control the following functions, which are described in 
further detail in this section:

•

Radio Type. Use this pull-down menu to specify the radio type.

•

AP Type. Use this drop-down box to select the AP model. 

•

Overlap Factor. Use this field and pull-down to specify an AP coverage overlap factor.

Note: The inter-floor height is not the distance from floor to ceiling. Some buildings 

have a large space between the interior ceilings and the floor above.