Netgear WFS709TP 사용자 설명서

5-12

Configuring WLANS

•

Ignore Broadcast Probe Request. When a client sends a broadcast probe request frame to 
search for all available SSIDs, this option controls whether or not the system responds for this 
SSID. When enabled, no response is sent and clients must know the SSID in order to associate 
to the SSID. When disabled, a probe response frame is sent for this SSID.

This setting can also be configured on a per-radio basis in the radio settings pages.

•

DTIM Period. Specifies the interval between the sending of Delivery Traffic Indication 
Messages (DTIMs) in the beacon. This is the maximum number of beacon cycles before 
unacknowledged network broadcasts are flushed. When using wireless clients that employ 
power management features to sleep, the client must revive at least once during the DTIM 
period to receive broadcasts. The default is 2.

This setting can also be configured on a per-radio basis in the radio settings pages.

•

Mixed TKIP/AES-CCM encryption. Selecting this option displays additional selections: 

•

PSK TKIP/AES-CCM for static TKIP and AES key configuration

•

WPA/2 TKIP/AES-CCM for dynamic TKIP and AES

If you select PSK TKIP/AES-CCM, the key can be hex or ASCII. Enter a 64-character hex 
key or an 8-character to 63-character ASCII key.

Use the General configuration in the Advanced WLAN pages to configure AP logging and 
debugging, Simple Network Management Protocol (SNMP) system information and trap 
receivers, and other information.

•

To configure information that applies to all APs in the network, navigate to the Configuration 
> Advanced > WLAN > Network > General page (

).

To configure information that applies to APs in a specific location in the network:

1. Navigate to the Configuration > Advanced > WLAN > Advanced page.

2. Click Add to add a new location.

3. Enter a location ID in the format building.floor.plan, where each value is an integer.

4. Click Add.

5. Select the General tab.