Netgear WFS709TP 사용자 설명서
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
5-20
Configuring WLANS
v1.1, November 2008
•
The AP response time to noise is quick and reliable, even to non-802.11 noise, especially
when client traffic starts generating errors due to the noise.
when client traffic starts generating errors due to the noise.
•
Non-802.11 noise detection is disabled by default and must be explicitly enabled.
•
The ARM algorithm is based on what the AP hears, which means that the system can
compensate for scenarios like broken antennas or blocked signal coverage on neighboring
APs.
compensate for scenarios like broken antennas or blocked signal coverage on neighboring
APs.
•
Since channel decisions are based on the information the AP receives from the RF
environment, interference due to third-party APs is taken into account.
environment, interference due to third-party APs is taken into account.
Configuring ARM
1. Enable ARM for each AP and for the 802.11b/g radio.
•
To enable ARM under the global setting, navigate to Configuration > Advanced > WLAN
> Radio.
> Radio.
•
To enable ARM for individual APs, navigate to Configuration > Advanced > WLAN >
Advanced.
Advanced.
•
To enable ARM on the 802.11b/g radio, navigate to the Configuration > Advanced >
WLAN > Radio page (
WLAN > Radio page (
).
Figure 5-9