Netgear WFS709TP 사용자 설명서

2-6

Deploying a Basic WFS709TP System

2. (

 only) Configure a VLAN to connect the WFS709TP to your 

network. 

3. Connect the ports on the WFS709TP to your network.

4. (Optional) Configure a loopback address for the WFS709TP. 

When you connect to theWFS709TP for the first time using either a serial console or a web 
browser, the initial setup automatically launches. The initial setup requires you to set a master or 
local role for the WFS709TP and passwords for administrator and configuration access. You must 
also specify the country code for the country in which the WFS709TP will operate; this sets the 
regulatory domain for the radio frequencies that the APs use.

The initial setup requires that you configure an IP address for the VLAN 1 interface, which you 
can use to access and configure the WFS709TP remotely via a Secure Shell (SSH) or browser 
interface session. Configuring an IP address for the VLAN 1 interface ensures that there is an IP 
address and default gateway assigned to the WFS709TP upon completion of the initial setup.

Note: You do not need to perform this step if you are using VLAN 1 to connect the 

WFS709TP to the wired network.

Note: You do not need to perform this step if you are using the VLAN 1 IP address as 

the WFS709TP’s IP address.

Warning: Do not connect the WFS709TP Smart Wireless Switch to your network 

before you run the initial setup for these reasons:

•

The switch boots up with a default IP address which could interfere with 
your network. 

•

The DHCP server on the switch is first enabled and then disabled after setup 
is complete. If you connect the switch to your network before completing 
the initial setup, the DHCP server is active on your network