Netgear m6100 사용자 설명서

A number of other publications are available for your switch at 

including the following publications:

Refer to the M6100 Command Line Interface Manual for information about the command 
structure. The M6100 Command Line Interface Manual provides information about the 
CLI commands used to configure the switch. It provides CLI descriptions, syntax, and 
default values.

To configure the switch, you can access it through the console port, network interface, 
service port, or web management interface. For information about these options, see the 
following sections and information:

If a BootP or DHCP server exists on your network, you can perform the initial 
configuration over the network interface or service port. If no BootP or DHCP server 
exists on your network, you can perform the initial configuration through the CLI over the 
console port.

Access the web management interface over an Ethernet connection to perform the initial 

configuration.

Use the web management interface for configuration instead of the CLI. 
Web configuration is quicker and easier than entering the multiple 
required CLI commands. 

To access the console port on the switch, you need a VT100-compatible terminal or a 
computer that provides either a serial port or a USB port and that runs VT100 terminal 
emulation software.