Netgear 7000 Series 사용자 설명서

20-14

Managing Switch Stacks

•

Add the new stack unit to the stack using the process described in section 

. The unit can be inserted into the same position as the unit just removed, or 

the unit can be inserted at the bottom of the stack. In either case, make sure all stack cables are 
connected with the exception of the cable at the position where the new unit is to be inserted to 
insure that the stack does not get divided into two separate stacks, causing the election of a 
new master.

1. If particular numbering is required, it is recommended that stack members be assigned specific 

numbers when they are first installed and configured in the stack, if possible.

2. If the desired stack unit number for a particular unit is unused, a unit can be renumbered 

simply by using the switch <oldunit-id> renumber <newunit-id> CLI command. This 
command is found in global config mode.

3. If the newunit-id has been preconfigured, you may need to remove the newunit-id from the 

configuration before renumbering the unit.

4. If reassignment of multiple existing stack unit numbers is necessary, there are a number of 

implications in terms of mismatching of configuration. In this case, it is recommended that all 
units except the master be powered down and added back one at a time using the procedure in 
Section 

.

1. Using the movemanagement command, move the master to the desired unit number. The 

operation may take between 30 seconds and 3 minutes depending on the stack size and 
configuration. The command is movemanagement <fromunit-id> <tounit-id>

2. Make sure that you can log in on the console attached to the new master. Use the show switch 

command to verify that all units rejoined the stack. 

3. It is recommended that the stack be reset with the reload command after moving the master. 

1. First, move the designated master to a different unit in the stack using 

2. Second, using 

, remove the unit from the stack.