Netgear 7000 Series 사용자 설명서

22-2

IGMP Querier

Use the following CLI commands to set up the switch to generate IGMP querier packet for a 
designated VLAN. The IGMP packet will be transmitted to every ports on the VLAN. The 
following example enables the querier for VLAN 1. See the CLI Manual for more details about 
other IGMP querier command options.

To see the IGMP querier status, use the following command.

The command shows that the IGMP admin mode is Active. The mode is controlled by the 
ip igmpsnooping command. If the mode is inactive, no query packet is sent.

(Netgear switch) #vlan database

(Netgear switch) (vlan)#ip igmp 1

(Netgear switch) (vlan)#ip igmpsnooping querier 1

(Netgear switch) (vlan)#exit

(Netgear switch) #config

(Netgear switch) (config)#ip igmpsnooping

(Netgear switch) (config)#exit

(Netgear switch) #show ip igmpsnooping querier 1

Vlan ID........................................ 1

Admin Mode..................................... Active

Query IP Address............................... 10.10.10.1

Querier Interval............................... 60

Query Packets Sent Count....................... 242