Netgear 7000 Series 사용자 설명서
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
DNS
23-3
v1.0, May 2008
Example 2#: Manually Add a Host Name and an IP Address
The following example shows commands to add a static host name entry to the switch so that you
can use this entry to resolve the IP address.
can use this entry to resolve the IP address.
The example is shown as CLI commands and as a Web interface procedure.
CLI Commands
To use the CLI to manually add a host name and an IP address, enter the following CLI
commands:
commands:
Web Interface Procedure
To use the Web interface to manually add a host name and an IP address, proceed as follows:
1. From the main menu, select System > Management > DNS > Host Configuration. A screen
similar to the following displays.
(Netgear Switch)#config
(Netgear Switch) (Config)#ip host www.netgear.com 206.82.202.46
(Netgear Switch) (Config)#ip domain-lookup
(Netgear Switch) (Config)#ping www.netgear.com
Send count=3, Receive count=3 from 206.82.202.46
Figure 23-2