Netgear 7000 Series 사용자 설명서

2-5

Connect a terminal to the switch to begin configuration.

Ask the system administrator to determine whether you will configure the switch for in-band or 
out-of-band connectivity.

In-band connectivity allows you to access the switch from a remote workstation using the Ethernet 
network. To use in-band connectivity, you must configure the switch with IP information (IP 
address, subnet mask, and default gateway).

Configure for In-band connectivity using one of the following methods:

•

BootP or DHCP

•

EIA-232 port

You can assign IP information initially over the network or over the Ethernet service port through 
BootP or DHCP. Check with your system administrator to determine whether BootP or DHCP is 
enabled.

You need to configure the BootP or DHCP server with information about the switch—obtain this 
information through the serial port connection using the 

 command. Set up the 

server with the following values:

Unique IP address for the switch. Each IP parameter is made up of 
four decimal numbers, ranging from 0 to 255. If there is no DHCP 
server available to assign an IP address to the switch via DHCP, the 
default IP address for the switch is 169.254.100.100.

Subnet mask for the LAN