Netgear 7000 Series 사용자 설명서

2-10

Getting Started

This section contains procedures to help you become acquainted quickly with the switch software.

Before installing switch software, you should verify that the switch operates with the most recent 
firmware.

1. Configure the switch for In-band or Out-of-Band connectivity. In-band connectivity allows 

access to the software locally or from a remote workstation. You must configure the device 
with IP information (IP address, subnet mask, and default gateway).

2. Turn the Power ON.

3. Allow the device to load the software until the login prompt appears. The device initial state is 

called the default mode.

4. When the prompt asks for operator login, do the following steps:

–

Type admin

at the login prompt. Since a number of the Quick Setup commands require 

administrator account rights, log in to an administrator account.

–

Do not enter a password because the default mode does not use a password.

–

Check the CLI User EXEC prompt is displayed.

–

Enter 

 to switch to the Privileged EXEC mode from User EXEC. 

–

Enter 

 to switch to the Global Config mode from Privileged EXEC. 

–

Enter 

 to return to the previous mode.

–

Enter 

to show a list of commands that are available in the current mode. 

This section describes the commands you use to view system information and to setup the network 
device. Table 2-1 contains the Quick Start commands that allow you to view or configure the 
following information: 

•

Software versions

•

Physical port data

•

User account management

•

IP address configuration