Netgear 7000 Series 사용자 설명서
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Virtual Router Redundancy Protocol
8-3
v1.0, May 2008
Example #1: Configure VRRP on a Master Router
The following is an example of configuring VRRP on a 7000 Series Managed Switch acting as the
master router:
master router:
Enable routing for the switch. IP forwarding will then be enabled
by default.
by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip routing
Configure the IP addresses and subnet masks for the port that will
particpate in the protocol.
particpate in the protocol.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
Enable VRRP for the switch.
(Netgear Switch) (Config)#ip vrrp
Assign virtual router IDs to the port that will particpate in the
protocol.
protocol.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20
Specify the IP address that the virtual router function will rec-
ognize. Note that the virtual IP address on port 1/0/2 is the same
as the port’s actual IP address, therefore this router will always
be the VRRP master when it is active. And the priority default is
255.
ognize. Note that the virtual IP address on port 1/0/2 is the same
as the port’s actual IP address, therefore this router will always
be the VRRP master when it is active. And the priority default is
255.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 ip 192.150.2.1
Enable VRRP on the port.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 mode
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit