Netgear DS104 사용자 설명서

 

Model DS104/DS106/DS108/DS116 Dual Speed Hub Installation Guide

 

When installation is complete and power has been applied to the hub, the
following conditions should exist:

•

Power LED is on.

•

Link LED on each connected port is on.

•

Utilization LEDs on the front panel are blinking when data is being received 
by any port in the hub, and the Link/Receive LED on the connected port is 
blinking when data is being received by that port.

If there are any problems, refer to the Troubleshooting table.

 

Link LED off 
or 
intermittent

Port 
connection 
not 
functioning

Make sure the power cord is properly connected and 
functioning.
Check the crimp on the RJ-45 connectors and make sure 
that the plug is properly inserted and locked into the port 
at both the hub and the device. Make sure cabling is 
Category 5 and meets the requirements for 100 Mbps 
operation.
Check installation of the network interface cards and 
verify that they are 100 Mbps capable. Be sure that the 
proper software driver is loaded. Check link LEDs on the 
network adapter card and PC or workstation. Make sure 
cables and connectors are correct.

Collision 
LED on or 
blinking

Collisions 
taking place 
on network 
segment(s)

Excessive collisions can be caused by incorrect cabling, 
connectors, or wiring techniques or can occur when the 
network is too busy. Ensure that the PC at the far end is 
set to half-duplex mode and is operating properly. 

Problems 
with port 4 
(DS104) or 
port 6 
(DS106) or 
port 8 
(DS108) or 
port 16 
(DS116)

Normal/
Uplink push 
button in the 
wrong 
position

Check the Normal/Uplink push button on the front panel.