Nikon KT-10FV2 전단

Interpreting LED Indicators

There are four diagnostic LED indicators provided on the

transceiver to indicate the operation status as below:

Link

Cable link status

On

The cable link is ok

Off

No cable link or the link is
faulty.

Blink

The cable link is faulty.

TRX

Transmission status Blink

Transmission is in operation.

Off

No transmission.

On

Normal, if large transmission is
in operation.
Problem, if no transmission.

RCV

Receiving status

Blink

Receiving data packet

Off

No packet is being received.

On

Normal, if heavy traffic load.
Problem, if no network traffic.

COL

Collision status

Off

No collision occurs.

Blink

There is presence of collisions.

Installation

Attaching to an Ethernet device via an AUI cable

The Ethernet device can be a network interface controller,

wiring concentrator, or repeater that provides an AUI port.

For attaching to such device, an AUI cable of appropriate

length is required. The following figure illustrates the

connection of the transceiver and an Ethernet device via

an AUI cable.

Important:

If the transceiver is attached to an Ethernet repeater, a

10Base-T hub, or a wiring concentrator, the SQE test

function should be disabled.

Connecting to a fiber optic cable segment

The transceiver has two ST female connectors for hooking

up to a duplex fiber optic cable segment. One ST connec-

tor is used for transmitting data and the other one is used

for receiving data. Two fiber optic cables are required to

compose a duplex cable segment between the transceiver

and the Fiber Optic port at the other end of the cables.

The Fiber Optic port at the other end of the cables must

comply with IEEE 802.3 10Base-FL standard.