3com 4500 50-PORT 사용자 설명서
Ethernet Port Configuration Commands
53
Parameter
None
Description
Use the
loopback-detection enable
command to enable port loopback
detection. If there is a loopback port found, the switch will put it under control.
Use the
Use the
undo loopback-detection enable
command to disable port loopback
detection.
Loopback detection of a specified port only functions after port loopback
detection is enabled in the System or Ethernet port view. By default, port loopback
detection is disabled.
detection is enabled in the System or Ethernet port view. By default, port loopback
detection is disabled.
Related commands:
display loopback-detection
Example
To enable port loopback detection, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]loopback-detection enable
[4500]interface ethernet 1/0/1
[4500-Ethernet1/0/1]loopback-detection enable
[4500-Ethernet1/0/1]
loopback-detection
interval-time
Syntax
loopback-detection interval-time time
undo loopback-detection interval-time
View
System View
Parameter
time:
Specifies the interval of monitoring external loopback conditions of the
port. It ranges from 5 to 300, measured in seconds.
By default, the interval is 30 seconds.
Description
Use the
loopback-detection interval-time
command to configure the
detection interval for the external loopback condition of each port. Use the
undo
loopback-detection interval-time
command to restore the default interval.
Related commands:
display loopback-detection
Example
To configure the detection interval for the external loopback condition of each
port to 10 seconds, enter the following:
port to 10 seconds, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]loopback-detection interval-time 10