3com 5104M-FIB 사용자 설명서
2-200
SET PORT TYPE
SET PORT TYPE
Use the SET PORT TYPE command to define ports on any ONline FDDI Media
Module as master or slave ports. All FDDI Media Module ports default to a Type
M (master). Ports 1 and 2 can, however, be designated as Type S (slave) ports.
Designate your S ports before enabling the ports on the module.
Module as master or slave ports. All FDDI Media Module ports default to a Type
M (master). Ports 1 and 2 can, however, be designated as Type S (slave) ports.
Designate your S ports before enabling the ports on the module.
Ports 3 through 8 operate only as Type M ports. Therefore, the SET PORT TYPE
command is not available for ports 3 through 8. Refer to the appropriate FDDI
module documentation for information on Type M and Type S ports.
command is not available for ports 3 through 8. Refer to the appropriate FDDI
module documentation for information on Type M and Type S ports.
Format
Example
The following command sets port 1 in slot 7 to be a slave port:
CB5000> set port 7.1 type slave
Type set to SLAVE.
Related Commands
SHOW PORT
SET PORT PERSONALITY
SET PORT PERSONALITY
slot.port
Selects a port to define as master or slave.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 8) is the port number on the specified module.
For example, to specify port 2 on the module with slot ID 6, enter
and port (1 through 8) is the port number on the specified module.
For example, to specify port 2 on the module with slot ID 6, enter
6.2
master
Specifies the port as the primary communication port. This is the
default.
default.
slave
Specifies that the port runs as a backup to the master port in
redundant configurations. Used when a cable failure could take down
an entire network.
redundant configurations. Used when a cable failure could take down
an entire network.
set port
type
master
slave
slot.port