Siemens 6ED1050-1AA00-0BE8 사용자 설명서
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
102
Manual, 04/2011, A5E03556174-01
In our example we do not use the reset input of the off-delay function, and we identify it with
an 'x' connector.
4
3DU
[
%
%
7KLVLVZKDWWKHGLVSOD\VKRXOGQRZVKRZ
Assigning block parameters
Now you set the off-delay time T:
1. Move the cursor to Par, if it not already at this position: Press or
2. Switch to editing mode: Press OK
LOGO! shows the parameters in the parameter assignment window:
1. Move the cursor to Par, if it not already at this position: Press or
2. Switch to editing mode: Press OK
LOGO! shows the parameters in the parameter assignment window:
7 V
%5
7LPHYDOXH
7LPHEDVH
ಯರPHDQV7KHSDUDPHWHULVVKRZQ
DQGFDQEHPRGLILHGLQWKHSDUDPHWHU
DVVLJQPHQWPRGH
ಯ5ರPHDQV5HWHQWLYLW\LVHQDEOHGIRU
WKLVEORFN
DQGFDQEHPRGLILHGLQWKHSDUDPHWHU
DVVLJQPHQWPRGH
ಯ5ರPHDQV5HWHQWLYLW\LVHQDEOHGIRU
WKLVEORFN
77KHEORFN
SDUDPHWHU%LVD
WLPHIXQFWLRQ
SDUDPHWHU%LVD
WLPHIXQFWLRQ
To change the time value:
● Press and to position the cursor.
● Press and to modify the value at the relevant position.
● Confirm your entries with OK.
● Press and to position the cursor.
● Press and to modify the value at the relevant position.
● Confirm your entries with OK.
Setting the time
Set the time T = 12:00 minutes:
1. Move the cursor to the first digit: Press or
2. Select the digit '1': Press or
3. Shift the cursor to the second digit: Press or
4. Select digit '2': Press or
5. Move the cursor to the unit: Press or
6. Select the timebase 'm' (for minutes): Press or
1. Move the cursor to the first digit: Press or
2. Select the digit '1': Press or
3. Shift the cursor to the second digit: Press or
4. Select digit '2': Press or
5. Move the cursor to the unit: Press or
6. Select the timebase 'm' (for minutes): Press or