Siemens ERTEC200 사용자 설명서
UARTLCR_H
R/W Addr.: 0x4000_2308 Default: 0x00
Description
UART line control register high byte bit rate and control register bits 22 to 16
Bit No.
Name
Description
0 BRK
Send break = 1 A LOW level is sent continuously at the Transmit output.
1 PEN
Parity enable = 1 Parity check and generation are enabled.
2 EPS
If PEN = 1
Even parity select = 1
Even parity select = 1
Even parity (1) for check and generation.
Even parity select = 0
Odd parity (0) for check and generation.
3 STP2
Two stop bit select = 1 Two stop bits are appended at the end of the frame
when sending.
Two stop bit select = 0 One stop bit is appended at the end of the frame
when sending.
when sending.
Two stop bit select = 0 One stop bit is appended at the end of the frame
when sending.
4 FEN
FIFO enable = 1 FIFO modes for sending and receiving are enabled.
FIFO enable = 0 FIFO is disabled. Sending/receiving is then performed via
1-byte holding registers.
FIFO enable = 0 FIFO is disabled. Sending/receiving is then performed via
1-byte holding registers.
6 – 5
WLEN
Word length indicates the number of data bits within a frame.
00 5-bit data
01 6-bit data
10 7-bit data
11 8-bit data
01 6-bit data
10 7-bit data
11 8-bit data
7 -------
Reserved
Value is undefined
Value is undefined
UARTLCR_M
R/W Addr.: 0x4000_230C Default: 0x00
Description
UART line control register middle byte baud rate high byte bits 15 - 8
Bit No.
Name
Description
7 – 0
BAUD DIVMS
Baud rate divisor high byte
UARTLCR_L
R/W Addr.: 0x4000_2310 Default: 0x00
Description
UART line control register low byte baud rate low byte bits 7 - 0
Bit No.
Name
Description
7 – 0
BAUD DIVLS
Baud rate divisor low byte
NOTE: The baud rate divisor is calculated according to the following formula:
F
UARTCLK
BAUDDIV = ------------------------- - 1
16 * baud rate
Zero is not a valid divisor.
UARTLCR consists of 3 bytes. Writing of bytes is complete when UARTLCR_H has been written. If one of the first two
bytes is to be changed, UARTLCR_H must be written at the end following the change.
Example: Write UARTLCR_L and/or UARTLCR_M, write UARTLCR_H as acceptance.
Write UARTLCR_H only means write and accept UARTLCR_H bits.
Copyright © Siemens AG 2007. All rights reserved.
51
ERTEC 200 Manual
Technical data subject to change Version 1.1.0