Siemens E50001-F710-A420-X-4A00 사용자 설명서
Introduction
Introduction
The type Vector® manual group-operated
switch is designed to meet all applicable
ANSI, NEMA and IEEE standards.
The type Vector® manual group-operated
switch is designed to meet all applicable
ANSI, NEMA and IEEE standards.
Successful application and operation of
this equipment depends as much upon
proper installation and maintenance by the
user as it does upon the proper design and
fabrication by Siemens.
this equipment depends as much upon
proper installation and maintenance by the
user as it does upon the proper design and
fabrication by Siemens.
The purpose of this instruction manual is
to assist the user in developing safe and
efficient procedures for the installation,
maintenance and use of the equipment.
to assist the user in developing safe and
efficient procedures for the installation,
maintenance and use of the equipment.
Contact the nearest Siemens
representative if any additional
information is desired.
representative if any additional
information is desired.
Arc flash hazard and hazardous voltages.
Will cause death, serious injury or property damage.
Always de-energize and ground the equipment before
maintenance. Read and understand this instruction manual
before using equipment. Maintenance should be performed only
by qualified personnel. The use of unauthorized parts in the
repair of the equipment or tampering by unqualified personnel
will result in dangerous conditions which will cause death, severe
injury or equipment damage. Follow all safety instructions
contained herein.
maintenance. Read and understand this instruction manual
before using equipment. Maintenance should be performed only
by qualified personnel. The use of unauthorized parts in the
repair of the equipment or tampering by unqualified personnel
will result in dangerous conditions which will cause death, severe
injury or equipment damage. Follow all safety instructions
contained herein.
Arc flash hazard, hazardous voltages and high-speed moving
parts.
parts.
Will cause death, serious injury or property damage.
To avoid arc flash burns, electrical shock and entanglement in
moving parts, only qualified personnel should work on or around
this equipment after becoming thoroughly familiar with all
danger or warning notices, and procedures contained herein.
Personnel must observe all applicable regulations (e.g., OSHA),
follow all requirements of NFPA 70E and adhere to specific
operating procedures applicable to the installation. Use
appropriate personal protective equipment (PPE) for the voltage
and arc flash incident energy exposure.
moving parts, only qualified personnel should work on or around
this equipment after becoming thoroughly familiar with all
danger or warning notices, and procedures contained herein.
Personnel must observe all applicable regulations (e.g., OSHA),
follow all requirements of NFPA 70E and adhere to specific
operating procedures applicable to the installation. Use
appropriate personal protective equipment (PPE) for the voltage
and arc flash incident energy exposure.
4