Siemens SCALANCE X-200 사용자 설명서

 

Configuration / diagnostics using remote 

mechanisms 

6

6.1 

Assignment of an IP address 

6.1.1 

Introduction 

Initial assignment of an IP address 

 

Note 

 

The initial assignment of an IP address for an IE Switch X-200 is not possible with Web 

Based Management because this configuration tool requires that an IP address is already 

available.  

 

The IP address can only be assigned when the IE switch X-200 can be reached via Ethernet.  
There are three ways of assigning an IP address to an unconfigured device, using:  
●  DHCP 
●  STEP 7 V 5.3 plus SP 1 or higher  

If you want to assign an IP address using STEP 7, the forwarding of DCP frames to the 

relevant IE switch X-200 must not be disabled. 

●  Primary Setup Tool V3 or higher  

If you want to assign an IP address using the PST tool, the forwarding of DCP frames to 

the relevant IE switch must not be disabled. 

 

6.1.2 

Configuration with the Primary Setup Tool 

6.1.2.1 

Configuration with the Primary Setup Tool 

Primary Setup Tool (PST) 

The Primary Setup Tool is on the CD supplied with the device. 

SCALANCE X-200 
Operating Instructions, 12/2011, A5E00349864-19 

147