StarTech.com SV565USAGB 사용자 설명서

Instruction Manual

8

Afterwards the key will need to be re-formatted to return to normal use.
To upgrade all the Receiver units and the Transmitter Unit, plug the USB key into the 

first Receiver Unit of the chain. If it is plugged into another Receiver Unit it will only 

upgrade itself. This can be used to upgrade a new Receiver Unit that has recently been 

added.
While it is upgrading do not disconnect any cables, power off or reset any of the 

units. This will interfere with the process and possibly render it non-functional. If this 

happens, simply unplug the USB key when the light stops flashing and plug it back in 

to start the upgrade again.
After the console extender units have been upgraded successfully, unplug the USB key.

Troubleshooting

•  Ensure it is not in fixed calibration mode, then press the calibration button
•  If test pattern is not displayed it may be a communication issue or cable problem 

between the Receiver and Transmitter units

•  For a long cable, individual pairs may exceed 300m causing connection problems
•  Ensure that Cat5e cable is being used.
•  Make sure none of the cables are damaged, broken or exposed to excessive 

interference

•  Ensure video source is connected to IN port of Receiver Unit
•  Unplug then plug in the power for both the Transmitter and Receiver units
•  Test the Cat5 cable with a proper cable tester, to ensure cable integrity and signal 

throughput

•  vCtrl too low, use manual control to increase it
•  RGB color skew may also need manual adjustment
•  Over very long distances this may be unavoidable
•  Test the Cat5 cable with a proper cable tester, to ensure cable integrity and signal 

throughput