Avaya 580 사용자 설명서
12-12
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
2. See
to configure the IP Global Configuration Web page.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Table 12-2. IP Global Configuration Parameters
Parameter
Allows you to...
IP Unicast
Forwarding
Forwarding
Disable IP Unicast Forwarding. Must be enabled for
Unicast Forwarding. The default setting is Enable.
Unicast Forwarding. The default setting is Enable.
IP Multicast
Forwarding
Forwarding
Enable IP multicast forwarding on a global basis. Must be
enabled for Multicast Routing or Forwarding. The default
setting is Disable.
enabled for Multicast Routing or Forwarding. The default
setting is Disable.
IP Source Routing
Disable IP source routing globally. The default setting is
Enable.
Enable.
VRRP
Disable VRRP globally. The default setting is Enable.
BOOTP/DHCP
Relay Agent
Relay Agent
Enable Client requests for an IP address and forwards
their requests to a server. This agent also relays responses
from the server to the client. The default setting is Disable.
their requests to a server. This agent also relays responses
from the server to the client. The default setting is Disable.
BOOTP/DHCP
Option 82-Circuit
Info
Option 82-Circuit
Info
Enable This sub-option 82 identifies the slot and physical
port number from which the DHCP request was received.
The default setting is Disable.
port number from which the DHCP request was received.
The default setting is Disable.
Note:
BOOTP/DHCP Relay Agent must be set to
enable, and must be enabled on the desired IP
interface (enabled by default).
interface (enabled by default).
BOOTP/DHCP
Option 82- Agent
Info
Info
Enable This sub-option 82 identifies the IP address and, if
available, the system name of the switch. The Default
setting is Disable.
available, the system name of the switch. The Default
setting is Disable.
Note:
BOOTP/DHCP Relay Agent must be set to
enable, and must be enabled on the desired IP
interface (enabled by default).
interface (enabled by default).
Limit Proxy ARP
to Same Network
to Same Network
Enable Proxy ARP on the same network. When enabled,
the router responds to ARP requests when the source and
target IP address are in the same IP network and different
IP subnets. When disabled, the router responds to ARP
requests when the source and target IP address are in
different networks.
The default setting is Disable.
the router responds to ARP requests when the source and
target IP address are in the same IP network and different
IP subnets. When disabled, the router responds to ARP
requests when the source and target IP address are in
different networks.
The default setting is Disable.
Use Default Route
for Proxy ARPs
for Proxy ARPs
Disable the use of the default route on your switch as the
route for Proxy ARPs. For example, if you have a default
route configured to reach the 0.0.0.0 IP address, then any
ARP request that does not match any of the other routes in
your IP routing table will automatically go to this default
route. The default setting is Enable.
route for Proxy ARPs. For example, if you have a default
route configured to reach the 0.0.0.0 IP address, then any
ARP request that does not match any of the other routes in
your IP routing table will automatically go to this default
route. The default setting is Enable.
1 of 3