Avaya 580 사용자 설명서

Document No. 10-300077, Issue 2

17-3

Configuring the IPX RIP Protocol

To configure IPX RIP interfaces using the CLI, enter the following 
command in Interface mode:

(config-if: <if name>)#

You can create and modify IPX RIP filters from either the Web Agent or the 
CLI.

To create and modify IPX RIP filters using the Web Agent:

1.  In the navigation pane, expand the Routing > IPX > RIP folders, and 

then click Filters. 

The IPX RIP Filters Web page is displayed in the content pane. See 

. Only the CREATE button is displayed when no filters are 

configured.

Triggered Updates

Select Disable to disallow RIP updates to be 
immediately transmitted to the network in response to 
changes in the network topology. The default is 
Enable.

Advertise Default 
Route Only

Select Enable to allow the advertising of the default 
network exclusively (subject to a route to the default 
network being known to the switch). The default is 
Disable.

Mode

Select the one of the following modes for the RIP 
interface:

• Talk/Listen - Send and receive advertisements.

• Talk Only - Send advertisements.

• Listen Only - Receive advertisements.

The default is Talk/Listen