Avaya C460 사용자 설명서

Chapter 2        Avaya C460 CLI Commands

106

Avaya C460 Reference Guide

Example:

User level: read-write, admin.
Use the set port duplex command to configure the duplex type of an Ethernet 
or Fast Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet 
interfaces to either full duplex or half duplex. 
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation. An error message is generated if you attempt to set the transmission 
type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

<module>/<port> [value]

Example:
To set port 1 on module 4 to full duplex:

User level: read-write, admin.
Use the set port edge admin state  command to set the port as an RSTP 
edge-port or non-edge-port.

seconds

Time interval in seconds — 0-65535

C460-1(super)# set port dot1x quiet-period 1/2 5000

module

Number of the module (3-6). If you do not specify a number, 
the ports on all the modules are shown.

port

Number of the port on the module. If you do not specify a 
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for 
example, 4/5-13 for ports 5 to 13 on module 4.

value

• full – set full-duplex transmission
• half – set half-duplex transmission

C460-1# set port duplex 4/1 full

Port 4/1 set to full-duplex.