Avaya C460 사용자 설명서

Chapter 2        Avaya C460 CLI Commands

Avaya C460 Reference Guide

109

User level: read-write, admin.
Use the set port flowcontrol command to set the send/receive mode for 
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each 
direction (send or receive) can be configured separately.

The syntax for this command is:

 [direction] <module/port> [value]

Example: 

direction

• receive – determines whether the port can receive 

administrative status from a remote device.  
Available only for Gigabit Ethernet modules with negotiation set to 
off.

• send – determines whether the local port can send 

administrative status to a remote device.  
Available only for Gigabit Ethernet modules with negotiation set to 
off.

• all – send and receive (symmetric flow control).

module

Number of the module.

port

Number of the port on the module.

value

• off – used with receive to turn off an attached device's ability 

to send flow-control packets to a local port. Used with send 
to turn off the local port's ability to send administrative 
status to a remote device.

• on – used with receive to require that a local port receive 

administrative status from a remote device. Used with send, 
the local port sends administrative status to a remote device.

C460-1# set port flowcontrol receive 5/1 on

Port 5/1 flow control receive administration status set to on

(port will require far end to send flowcontrol)

C460-1# set port flowcontrol send 5/1 off

Port 5/1 flow control send administration status set to off

(port will send flowcontrol to far end)