Avaya C460 사용자 설명서

Avaya C460 Reference Guide

241

Glossary

100-Mbps baseband Fast Ethernet specification based on the IEEE 802.3 standard. 
100BaseTX uses two pairs of either UTP (Unshielded Twisted Pair) or STP (Single 
Twisted Pair) wiring. One pair is used to receive data; the other is used to transmit 
data.

10-Mbps baseband Ethernet specification based on the IEEE 802.3 standard. 10BaseT 
uses two pairs of UTP (Unshielded Twisted Pair) wiring. One pair is used to receive 
data; the other is used to transmit data.

Conversion of an IP address into a corresponding physical address. This is usually 
done using ARP (Address Resolution Protocol). 

A special control module that interfaces between the network manager and the 
managed devices, using the MIB as a management terms dictionary. Network 
Agents relay device events and execute instructions via embedded software.

An audible or visible warning signal alerting designated management stations that 
a significant event has occurred on the network.

Address Resolution Protocol. A TCP/IP protocol used to convert an IP address into 
a physical address, such as an Ethernet address. The sender broadcasts an ARP 
request onto the TCP/IP network. The host whose IP address matches the requested 
address then replies with its physical hardware address.

A high-bandwidth connection between switches. A backbone link normally 
operates in Full Duplex Mode, sending packets in both directions simultaneously.

Refer to Beaconing.