Avaya C460 사용자 설명서
Chapter 2 Avaya C460 CLI Commands
48
Avaya C460 Reference Guide
ip icmp-errors
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Type configure at the command prompt to enter configure mode.
Use the icmp-error command to turn ICMP error messages on.
Use the no icmp-error command to turn ICMP error messages off.
Use the no icmp-error command to turn ICMP error messages off.
The syntax for this command is:
[no] ip icmp-errors
Example:
To turn the ICMP error messages on:
To turn the ICMP error messages on:
ip max-arp-entries
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip max-arp-entries command to set the maximum number of ARP
cache entries allowed in the ARP cache.
Use the no ip max-arp-entries command to restore the default value of 4096.
This command takes effect only after start-up.
cache entries allowed in the ARP cache.
Use the no ip max-arp-entries command to restore the default value of 4096.
This command takes effect only after start-up.
The syntax for this command is:
[no] ip max-arp-entries
<value>
Example:
To set the maximum number of ARP cache entries to 8000:
To set the maximum number of ARP cache entries to 8000:
C460-1(configure)# ip icmp-errors
Done!
value
The space available for the IP address table. When you decrease the
number of entries, it may cause the table to be relearned more
frequently. If you do not enter a value, then the current ARP Cache
size is shown.
number of entries, it may cause the table to be relearned more
frequently. If you do not enter a value, then the current ARP Cache
size is shown.
C460-1(configure)# ip max-arp-entries 8000