Avaya P332MF 사용자 설명서

Chapter 6

CLI – Layer 2

Avaya P332MF User’s Guide

99

Output Example:

P330-N# set interface ppp enable

Entering the Modem mode within 60 seconds...

Please check that the proprietary modem cable is plugged into 

the console port

Output Example:

P330-N# set interface ppp disable

Entering the Terminal mode immediately

Use the

 set port level 

command to set the priority level of a port. Untagged 

(without an 802.1p priority header) packets travelling through ports set with 
priority 0-3 will be served only after packets traveling through ports set with 
priority 4-7 in case of congestion. Packets arriving with an 802.1p priority header 
will not be modified by this command.

The syntax for this command is:

set port level <mod_num>/<port_num> {value}

Output Example:
To set the priority level for port 2 on module 1 to 7:

P330-N# set port level 1/2 7

Port 1/2 port level set to 7

Use the

 set port negotiation 

command to enable or disable autonegotiation 

on a port. If autonegotiation is disabled, you can set port parameters using the 
relevant CLI commands. If autonegotiation is enabled, these commands have no 
effect. For Fiber Gigbit Ethernet ports it can determine the flow control (pause) 
mode only.

Copper ports in the P332GT-ML can work at 1000Mbps (Full Duplex) only if 

autonegotiation is enabled on both cable ends and you are using a 4 pair (8 wires) 
Ethernet cable. If autonegotiation is disabled, these ports can only work at 100Mbps 
(Full Duplex), and autonegotiation should be disabled on both cable ends.

value

Priority level (0-7)