Avaya P332MF 사용자 설명서

Chapter 6

CLI – Layer 2

104

Avaya P332MF User’s Guide

Example:

P330-N# set port static-vlan 1/4-6 9   

Use the 

set port self-loop-discovery Admin_Status 

command to 

enable or disable a port’s IBM token ring discovery mode. The port’s self-loop-
discovery feature is activated only after you enable the self-loop-discovery mode at 
the module level using the 

set self-loop-discovery Admin_status 

command.

This command is not supported by the P330-ML switches. 

The syntax for this command is:

set port self-loop-discovery Admin_Status <enable|disable> 

<module/port>

Output Example:

P330-N# set port self-loop-discovery Admin_Status enable 1/2

Self-Loop-Discovery enabled on port 1/2.

Use the

 set port channel 

command to enable or disable a Link Aggregation 

Group (LAG) interface on the switch. LAG creation requires a LAG name to be 
specified. There is no default name. 
You can also add or remove a port from an existing LAG. When adding or removing 
a port to an existing LAG, type the same LAG-name. All ports in the LAG are 
configured with the parameters of the first port that is added to the LAG. These 
parameters include port administrative status, speed, duplex, autonegociation 
mode, VLAN ID, tagging mode, binding mode, and priority level.  
The ports added to a LAG must belong to the same LAG group - refer to the “LAG” 
marking on device’s front panel.

The syntax for this command is:

set port channel [port_list] [value] [name]

port_list

Switch and ports to bundle (format: module/port)

value

on/off to enable/disable a channel for the specified module 
ports