Avaya M770 사용자 설명서

Chapter 10

Managing PNNI Routing

Avaya M770 ATM Switch User’s Guide

145

To show the admin status of all levels, use the following command:

Setting PNNI node admin status

Use the following command to set pnni node admin status. It takes effect only for 
logical levels (greater than 1).

The following command displays the ATM address of the PNNI node. The PNNI 
node's ATM address is advertised in Nodal Information PTSE and is important 
when the node is a PGL/LGN. In this case, an SVC-RCC shall be opened between 
LGNs, i.e., between the PNNI node's ATM addresses.

Use the following command to set PNNI configuration with default parameters.

This request will set defaults for all configurable variables: PNNI node level, node 
id, peer group id, restrict transit flag, pgle parameters, svce parameters and all the 
timers for the pysical level. Changes won't take effect until the next reboot, except 
for timers, restrict transit flag and PGLE parameters.
For logical levels, changes will take place immediately.

Make sure the admin status of that level is down when you use this command 

on the logical level.

Command:

M15-155s8:/>route pnni config admin show 

Output: 

Admin Status:

Level 1 - Up

Level 2 - Up

Level 3 - Down

Level 4 - Down

Level 5 - Down

Command:

M15-155s8:/>route pnni config admin set <level> <up | down> 

Command:

M15-155s8:/>route pnni config atm_addr show [<level>]

Output: 

Atm address:

Level 1 -    39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.81

Level 2 -    39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.82

Level 3 -    39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.84

Level 4 -    39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.85

Level 5 -    39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.86 

Command:

M15-155s8:/>route pnni config default <level>