Avaya M770 사용자 설명서
Chapter 16
Managing an ELAN
Avaya M770 ATM Switch User’s Guide
223
To change the formula for LES address that a LEC will call, enter the
lane elan
lesaddress
command:
Note:
If only the name of the ELAN is entered then the LES address formula
currently in use will be displayed for the specified ELAN.
Changing the Maximum Number of LESes in an ELAN
This command is only valid if the specified ELAN supports distributed LANE
Services.
You must be aware of the following, if you change the number of distributed LESes
that the ELAN supports:
•
Services.
You must be aware of the following, if you change the number of distributed LESes
that the ELAN supports:
•
If the maximum is increased the change will take effect immediately and
additional standby LES(es) will be promoted to active (if there are any).
additional standby LES(es) will be promoted to active (if there are any).
•
If the maximum is decreased the change will not affect the number of LESes
currently providing LE Services, but rather will determine whether active LESes
which get timed-out, get re-admitted or replaced by a standby LES.
currently providing LE Services, but rather will determine whether active LESes
which get timed-out, get re-admitted or replaced by a standby LES.
Command:
M15-155s8:/>lane elan lesaddress <name> <les-address-formula> [<group-address>]
Example:
M15-155s8:/>lane elan lesaddress accounts_elan longest_match
Parameters:
<name>
The name of the ELAN. The name must be 32 characters or less.
<les-address-formula>
Select one of the following formulas that the LEC will used to
locate the LES address: "group_address", "round_robin", or
"longest_match".
locate the LES address: "group_address", "round_robin", or
"longest_match".
<group-address>
This parameter is only required, if a new group ATM address is
being supplied. It must be a 20-byte ATM address.
being supplied. It must be a 20-byte ATM address.