Avaya M770 사용자 설명서

Chapter 17

Managing System Commands

Avaya M770 ATM Switch User’s Guide

233

Using Terminal Commands

These commands allow you to configure how the Avaya M770 ATM Switch 
displays output on the terminal.

The pager is a facility that enables you to view the information that the M770 ATM 
Switch outputs to the screen, a number of lines at a time. By default, the pager is 
enabled. 
To display the pager status, use the

terminal pager

 

command. 

If the pager is enabled, the M770 ATM Switch displays output on the terminal 
screen, a number of lines at a time. To enable the pager, use the

terminal pager 

enable

 

command. 

If the pager is disabled, the M770 ATM Switch displays output on the terminal 
screen continuously. To disable the pager, use the

terminal pager disable

 

command. 

If the pager is enabled, this is the number of lines that the M770 ATM Switch will 
output before pausing. For more information about the pager, see Viewing the 
prompt later in this chapter. 
By default, the number of terminal lines is set to 24.
To display the current number of lines, use the

terminal lines

 

command. 

Command:

M15-155s8:/>terminal pager

Output:

pager is enabled

Command:

M15-155s8:/>terminal pager enable

Output:

pager enabled

Command:

M15-155s8:/>terminal pager disable

Output:

pager disabled

Command:

M15-155s8:/>terminal lines

Output:

terminal ines: 24 (auto-detected) 

(user-configured)