Avaya M770 사용자 설명서
Chapter 5
Managing Physical Ports
44
Avaya M770 ATM Switch User’s Guide
Displaying counter information for DS3 physical ports
You can view counter information specific only to DS3 modules by entering the
command:
command:
pport show ds3counters
. The information this command displays
will not appear when you enter the command:
pport show counters.
DS3 Counter information is accumulated in 15 minute completed intervals for the
last 24 hours the system was up. Fewer than 96 intervals of information will be
available if the module has been restarted within the last 24 hours.
There are 96 (15 minute) intervals numbered 1-96 with interval 0 always the current
interval, interval 1 the interval most recently completed, and interval 96 the earliest
possible interval. As soon as the current 15 minute interval ends, a new current
interval 0 starts.
last 24 hours the system was up. Fewer than 96 intervals of information will be
available if the module has been restarted within the last 24 hours.
There are 96 (15 minute) intervals numbered 1-96 with interval 0 always the current
interval, interval 1 the interval most recently completed, and interval 96 the earliest
possible interval. As soon as the current 15 minute interval ends, a new current
interval 0 starts.
The pport show ds3counters current
command displays counter
information only for the current interval. The
pport show ds3counters
interval
command displays a historical record of the counters for the completed
intervals (up to 96 completed intervals) during the last 24 hours the system was up.
Note:
The
pport show ds3counters
command displays counter information
specific only to DS3 modules.
Rx Errors
The number of cell errors that have been received through the
physical port.
physical port.
Command:
M4-DS3s8:/>pport show ds3counters [ne|fe] [current|total|interval [<pport id>]]
Example:
M4-DS3s8:/>pport show ds3counters ne current
Parameters:
ne
To specify that the counter information is supplied from the near
end.
end.
fe
To specify that the counter information is supplied from the far end.
current
To specify that the ne/fe counter information is supplied from the
current interval for all ports.
current interval for all ports.
total
To specify that the ne/fe counter information is supplied for the last
24 hours for all ports.
24 hours for all ports.
interval [pport id]
To specify that the ne/fe counter information is supplied in all
intervals (up to 96) for all ports.
intervals (up to 96) for all ports.
If the physical port identifier is entered, only the interval counters
for the specified DS3 port are displayed. If no value is specified, then
the interval counters for all DS3 ports are displayed.
for the specified DS3 port are displayed. If no value is specified, then
the interval counters for all DS3 ports are displayed.
Table 5.2
Output from the pport show counters command
Field
Description