Avaya P330-ML-ML 사용자 설명서

Chapter 2        Avaya P330-ML Layer 2 CLI Commands

Avaya P330-ML Reference Guide

95

User level: privileged, supervisor.
Use the set port name command to configure a name for a port. If you do not 
specify a name, the port name remains blank.

The syntax for this command is:

 <module>/<port> [<name>]

Example:

L If you wish to define a name which includes spaces, you must enclose the entire 

name in quotation marks, for example “new york”.

User level: privileged, supervisor.
Use the set port negotiation command to enable or disable the link 
negotiation protocol on the specified port. This command is available on Fast 
Ethernet or Gigabit Ethernet ports. 
When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are 
determined by auto-negotiation. 
If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet 
ports.
For Fiber Gigbit Ethernet ports it can determine the flow control (pause) mode only.
L Copper ports in the P332GT-ML can work at 1000Mbps (Full Duplex) only if 

autonegotiation is enabled on both cable ends and you are using a 4 pair (8 
wires) Ethernet cable. If autonegotiation is disabled, these ports can only work 
at 100Mbps (Full Duplex), and autonegotiation should be disabled on both cable 
ends.

module

Number of the switch.

port

Number of the port on the switch.

name

Name (up to 16 characters)

P330-N# set port name 4/21 arthur

Port 4/21 name set.