Avaya P330-ML-ML 사용자 설명서
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
102
Avaya P330-ML Reference Guide
The syntax for this command is:
set port spantree force-protocol-migration <module/port>
Example:
set port spantree priority
User level: privileged, supervisor.
Use the set port spantree command to set the Spanning Tree priority level of a
port. This value defines the priority of a port to be blocked in case two ports with
the same costs cause a loop.
Use the set port spantree command to set the Spanning Tree priority level of a
port. This value defines the priority of a port to be blocked in case two ports with
the same costs cause a loop.
The syntax for this command is:
set port spantree priority [module/port] [value]
Example:
L Priority value 0 will set the port to Root port.
set port speed
User level: privileged, supervisor.
Use the set port speed command to configure the speed of a port or range of
10/100BASE-T ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An
error message is generated if you attempt to set the speed when auto negotiation is
enabled
Use the set port speed command to configure the speed of a port or range of
10/100BASE-T ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An
error message is generated if you attempt to set the speed when auto negotiation is
enabled
module/
port
port
Port identifier
P330-N>set port spantree force-protocol-migration 1/1
port 1/1 is forced to send a Rapid spanning tree BPDU
module/port
Module number/port number.
value
Number representing the priority of the bridge. The
priority level is from 0 to 240, with 0 indicating high
priority and 240 indicating low priority. Value should be
in steps of 16; default value is 128.
priority level is from 0 to 240, with 0 indicating high
priority and 240 indicating low priority. Value should be
in steps of 16; default value is 128.
P330-N# set port spantree priority 3/4 128
port 3/4 spantree priority is 128