Avaya P330-ML-ML 사용자 설명서
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
238
Avaya P330-ML Reference Guide
Use the ip routing command to enable IP routing.
Use the no ip routing command to disable the IP routing process in the device.
By default, IP routing is enabled.
Use the no ip routing command to disable the IP routing process in the device.
By default, IP routing is enabled.
The syntax for this command is:
[no] ip routing
Example:
ip simulate
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate <access-list-number> [<priority>] [<dscp-
value>]<source> <destination> [<protocol> [<source port>
<destination port> [<established>]]]
Router-N(configure)# ip routing
Router-N(configure)#
access-list-number
nteger (100 - 149, 0 is the default list)
priority
fwd0 | fwd1 | - | fwd7
dspc value
dscp0 | dscp1 | - | dscp63
source
source ip address
destination
destination ip address
protocol
ip | tcp | udp | integer (1 - 255)
source port
integer (1 - 65535)
destination port
integer (1 - 65535)
established
value of TCP established bit