Avaya P330-ML-ML 사용자 설명서
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide
125
set trunk
User level: privileged, supervisor.
Use the set trunk command to configure the VLAN tagging mode of a port.
Use the set trunk command to configure the VLAN tagging mode of a port.
set trunk <module/port> {off|dot1q}
Example:
set utilization cpu
User level: privileged, supervisor.
Use the set utilization cpu command to enable CPU utilization monitoring
on the specified module.
Use the set utilization cpu command to enable CPU utilization monitoring
on the specified module.
The syntax for this command is:
set utilization cpu
<module-number>
Example:
module
Number of the switch.
port
Number of the port on the switch.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on switch 4.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on switch 4.
off
Forces the port to become a non-tagging port.
dot1q
Specifies an IEEE 802.1Q tagging on a Fast Ethernet or
Gigabit Ethernet port.
Gigabit Ethernet port.
P330-ML-1# set trunk 3/3 dot1q
Dot1Q VLAN tagging set on port 3/3.
module-
number
number
The module number for which CPU utilization monitoring is
enabled.
enabled.
P330-N# set utilization cpu 1
CPU utilization is set on module 1
Done!