Avaya P3343T-ML 사용자 설명서

Chapter 12        Avaya P330 Layer 3 Features

Avaya P334T-ML User’s Guide

125

This section is only applicable if you either purchased a Layer 3 preconfigured 
P334T-ML module or purchased a Routing License Key Certificate for P334T-ML 
and activated the License Key. For information, on activating a Licence Key, see 
Obtaining and Activating a License Key below.
To configure the initial router parameters perform the following via the CLI:
1

Enter set device-mode router and press Enter. 
You will be prompted to reset the module.

2

Type y.  
Wait for the module to restart and for the CLI prompt to reappear.

3

Type show device-mode and press Enter to ensure that the module is in 
router mode.

L Assign the stack IP address as described in Assigning P330’s IP Stack Address 

before you assign the Initial Router IP address.

4

To access Router commands from the Master module, type the command 
session 

<module number> router

 where <module number> is the 

location of the router module in the stack, and press Enter.  
The command prompt changes from P330-N> to Router-N#> where N is 
the number of the router in the stack (see P330 Sessions).

5

Type configure and press Enter. The prompt Router-N(configure)# 
appears.

L If the IP interface is on VLAN #1, continue with step 7.
6

Create the management/routing VLAN. Use the command  
set vlan 

<Vlan-id> name <Vlan-name> 

replacing <Vlan-id> by the 

Use this command before 
configuring VLAN-oriented 
parameters, when there is more 
than one interface on the same 
VLAN

enable vlan commands 

Display information about the IP 
unicast routing table

show ip route (Layer 3)

Display information for an IP 
interface

show ip interface 

Display the status of ICMP error 
messages

show ip icmp 

Delete a Layer 2 Router interface 

clear vlan

In order to...

Use the following command...