Brocade Communications Systems IPMC5000PEF 사용자 설명서
To disable PIM6 SM snooping, enter the no ipv6 pimsm-snooping command.
device(config)#no ipv6 pimsm-snooping
If you also want to disable IP multicast traffic reduction, enter the no ipv6 multicast command.
device(config)#no ipv6 multicast
Syntax: [no] ipv6 pimsm-snooping
Enabling PIM6 SM snooping on a VLAN
Perform the following steps to enable PIM6 SM snooping on a VLAN.
1.
Configure a VLAN and add the ports that are connected to the device and host in the same port-
based VLAN.
based VLAN.
device(config)#vlan 20
device(config-vlan-20)#untagged etherenet 1/1/5 ethernet 1/1/7 ethernet 1/1/11
2.
Enable MLD snooping passive on the VLAN.
device(config-vlan-20)#multicast6 passive
3.
Enable PIM6 SM snooping on the VLAN.
device(config-vlan-20)#multicast6 pimsm-snooping
Syntax: [no] multicast6 pimsm-snooping
Disabling PIM6 SM snooping on a VLAN
When PIM6 SM snooping is enabled globally, you can still disable it for a specific VLAN. For example,
the following commands disable PIM6 SM snooping for VLAN 20. This setting overrides the global
setting.
the following commands disable PIM6 SM snooping for VLAN 20. This setting overrides the global
setting.
device(config)#vlan 20
device(config-vlan-20)#multicast6 disable-pimsm-snoop
Syntax: [no] multicast6 disable-pimsm-snoop
PIM6 SM snooping show commands
This section shows how to display information about PIM6 SM snooping, including:
•
•
on page 67
Displaying PIM6 SM snooping information
To display PIM6 SM snooping information, enter the show ipv6 multicast pimsm-snooping
command.
command.
device#show ipv6 multicast pimsm-snooping
vlan 25, has 2 caches.
1 (0:11 1:3) has 2 pim join ports out of 2 OIF
1/1/2 (age=0), 2/1/3 (age=0),
Enabling PIM6 SM snooping on a VLAN
66
FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02