ZyXEL Communications XGS-4526 사용자 설명서
Chapter 13 Spanning Tree Protocol
XGS-4526/4528F/4728F User’s Guide
160
13.7 Multiple Rapid Spanning Tree Protocol
Status
Status
Click Advanced Application > Spanning Tree Protocol in the navigation panel
to display the status screen as shown next. See
to display the status screen as shown next. See
for
more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 66 Advanced Application > Spanning Tree Protocol > Status: MRSTP
Priority
Configure the priority for each port here.
Priority decides which port should be disabled when more than one port
forms a loop in the Switch. Ports with a higher priority numeric value
are disabled first. The allowed range is between 0 and 255 and the
default value is 128.
forms a loop in the Switch. Ports with a higher priority numeric value
are disabled first. The allowed range is between 0 and 255 and the
default value is 128.
Path Cost
Path cost is the cost of transmitting a frame on to a LAN through that
port. It is recommended that you assign this value according to the
speed of the bridge. The slower the media, the higher the cost - see
port. It is recommended that you assign this value according to the
speed of the bridge. The slower the media, the higher the cost - see
for more information.
Tree
Select which STP tree configuration this port should participate in.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 31 Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL
DESCRIPTION