ZyXEL Communications XGS-4526 사용자 설명서
Chapter 26 IP Source Guard
XGS-4526/4528F/4728F User’s Guide
280
26.7.2 ARP Inspection VLAN Configure
Use this screen to enable ARP inspection on each VLAN and to specify when the
Switch generates log messages for receiving ARP packets from each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Configure > VLAN.
Switch generates log messages for receiving ARP packets from each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Configure > VLAN.
Figure 128 ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Burst interval
(seconds)
(seconds)
The burst interval is the length of time over which the rate of ARP
packets is monitored for each port. For example, if the Rate is 15
pps and the burst interval is 1 second, then the Switch accepts a
maximum of 15 ARP packets in every one-second interval. If the
burst interval is 5 seconds, then the Switch accepts a maximum of
75 ARP packets in every five-second interval.
packets is monitored for each port. For example, if the Rate is 15
pps and the burst interval is 1 second, then the Switch accepts a
maximum of 15 ARP packets in every one-second interval. If the
burst interval is 5 seconds, then the Switch accepts a maximum of
75 ARP packets in every five-second interval.
Enter the length (1-15 seconds) of the burst interval.
Apply
Click Apply to save your changes to the Switch’s run-time memory.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel
Click this to reset the values in this screen to their last-saved
values.
values.
Table 87 ARP Inspection Port Configure (continued)
LABEL
DESCRIPTION
Table 88 ARP Inspection VLAN Configure
LABEL
DESCRIPTION
VLAN
Use this section to specify the VLANs you want to manage in the section
below.
below.
Start VID
Enter the lowest VLAN ID you want to manage in the section below.
End VID
Enter the highest VLAN ID you want to manage in the section below.
Apply
Click this to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified
above. If you configure the * VLAN, the settings are applied to all
VLANs.
above. If you configure the * VLAN, the settings are applied to all
VLANs.