ZyXEL Communications XGS-4526 사용자 설명서

 Chapter 29 Layer 2 Protocol Tunneling

XGS-4526/4528F/4728F User’s Guide

Click Advanced Application > Layer 2 Protocol Tunneling in the navigation 
panel to display the screen as shown. 

Figure 139   Advanced Application > Layer 2 Protocol Tunneling 

The following table describes the labels in this screen. 

Table 92   Advanced Application > Layer 2 Protocol Tunneling 

Active

Select this to enable layer-2 protocol tunneling on the Switch.

Destination 
MAC Address

Specify an MAC address with which the Switch uses to encapsulate the 
layer-2 protocol packets by replacing the destination MAC address in the 
packets.

Note: The MAC address can be either a unicast MAC address or 

multicast MAC address. If you use a unicast MAC address, 
make sure the MAC address does not exist in the address 
table of a switch on the service provider’s network. 

Note: All the edge switches in the service provider’s network should 

be set to use the same MAC address for encapsulation.

Port

This field displays the port number.